KraftMaid Driveway & Pavers Nationwide

KraftMaid Driveway & Pavers: The Mountain View Owner’s Guide

We stock and install KraftMaid-compatible driveway and paver systems in Mountain View, with paver driveway installations running $7,000-$18,000 and concrete driveway work at $4,500-$12,000 depending on substrate condition and square footage. Most KraftMaid paver consultations can be scheduled within 48 hours, and we carry common replacement edging, joint sand, and paver units for the brand’s outdoor living lines. Homeowners usually discover an issue when pavers start rocking underfoot, joints wash out after rain, or the edge restraint pulls away from the bedding course - all signs that the interlock system is degrading.

Call (669) 215-4852

Which KraftMaid Models This Applies To

KraftMaid’s outdoor offerings center on their Patio & Outdoor Living collection, which uses Belgard and Techo-Bloc manufactured pavers selected for color matching with their cabinet finishes. The critical compatibility gotcha: KraftMaid specifies a 6-inch edge restraint depth for their paver borders, while standard residential installs in Mountain View often use 4-inch. If your original install followed KraftMaid’s spec, swapping to generic 4-inch restraint will fail within two seasons as the bedding sand migrates.

To identify your exact system, check the project documentation for a KraftMaid job number starting with “KM-OUT-” followed by a four-digit year. The paver series is stamped on the edge restraint itself - “Belgard Cambridge” or “Techo-Bloc Blu” are the two we see most in Mountain View, particularly in the Monta Loma and Blossom Valley neighborhoods where KraftMaid outdoor kitchens were popular in 2018-2021 builds. OEM edge restraint from KraftMaid runs 30-40% above equivalent-grade Belgard direct, but the profile match is exact. We typically quote both and let the owner decide.

Signs Your KraftMaid Driveway & Pavers Is Failing

• Pavers rock or sink when stepped on. This means the bedding sand layer has eroded or compacted unevenly, breaking the interlock that distributes load across adjacent units. In Mountain View’s clay-heavy soils, this often follows a winter where water pooled against the edge rather than draining through the permeable base.
• Joint sand washes out after light rain. Polymeric sand degrades when the paver surface wasn’t fully dry during original application, or when the joint width exceeds 3/16 inch. KraftMaid specs call for Techniseal RG+ in joints over 1/8 inch - we’ve found cheaper substitutes failing at 18 months in CA sun.
• Edge restraint pulls away from the border course. The spike-down plastic or aluminum strip that locks the outer pavers in place has either corroded (steel spikes in our coastal-adjacent climate) or been undermined by irrigation runoff. Once the edge goes, the field pavers follow within a season.
• Surface efflorescence that doesn’t clean off. White mineral deposits indicate moisture moving through the paver body, usually from a base that wasn’t compacted to 98% standard Proctor density. KraftMaid’s warranty specifically excludes this if the base prep was subcontracted, which it often was.
• Cracking in concrete paver alternatives. KraftMaid’s “stone-look” concrete pavers from the 2019-2021 period had a known issue with freeze-thaw scaling in above-2,000-foot elevations. Mountain View itself is safe, but we’ve replaced these in Los Altos Hills and Portola Valley where the spec wasn’t adjusted for altitude.

Before

After

Replacement Cost & What’s Included

The spread in paver pricing comes down to three things: how much of the base can be salvaged (we test with a dynamic cone penetrometer), whether the original pavers are still available for spot repair, and access - tight Mountain View lots in Old Mountain View or near downtown require mini-excavator work that adds a day. Under Clause 1 of the Haven Standard, the written price you sign covers the full scope; if we hit unexpected substrate failure, we stop, photograph, and write a change order before continuing. No surprises on the invoice.

Our 365-Day Done Right Promise covers paver and concrete work against settling, joint failure, and edge pullout. The warranty is printed on your contract, not an asterisk.

DIY or Call Us?

There’s honest work an owner can do: sweep in fresh polymeric sand after power-washing, seal the surface every 3-4 years, and spot-replace a single lifted paver if the base underneath is still sound. Measure twice, write it down, then build it that way - or in this case, pull one paver, check the bedding layer, and replace with the same orientation.

Where DIY goes wrong: regrading the base without a plate compactor and laser level, which guarantees future settling. Edging repair requires cutting the existing restraint clean, setting at the correct depth, and anchoring with 10-inch spikes at 6-inch centers - miss the spacing and the restraint bows. More critically, any driveway or patio over 200 square feet in Mountain View requires a permit check for impervious surface coverage; we’ve seen owners pour concrete that triggered drainage compliance issues with the city. We pull permits as standard, included in our written scope.

If your pavers are moving or the edge is failing, call (669) 215-4852 and we’ll schedule a free estimate with a written line-item quote.

FAQs